Synopsys Cloud
Cloud native EDA tools & pre-optimized hardware platforms
Request a Free Trial →
Register Once To Access All The Lectures
Listen to lectures presented by Professor Mohammed Ismail and Professor Mohammad Alhawari from the WINCAS Center of Excellence at Wayne State University. In these lectures analog design engineers will learn about the design, and verification of an ADC for 5G V2X (Vehicle-to-everything) application, using the GlobalFoundries (GF) 22 nm FDSOI technology.
Mohammed Ismail
Chair & Professor, Electrical and Computer Engineering , Wayne State University
Mohammad Alhawari
Assistant Professor, Electrical and Computer Engineering, Wayne State University
Lecture 1: Introduction to 5G Technology in the Automotive Industry
- Introduction to the 5G in Automotive Industry
- TI SAR ADCs for multiband V2X applications
- Introduction to GF 22 nm FDSOI Technology
Lecture 2: Design of the Track and Hold Circuit
- Design of the Track and Hold circuit
Lecture 3: Choosing Capacitor Types for a DAC in Monotonic SAR ADCs
- Choosing capacitor types for DAC in Monotonic SAR ADC
- Comparator design and kickback noise
Lecture 4: Monotonic SAR Logic Design Issues
- Monotonic SAR Logic Design issues
- Robustness of SAR ADC across all corners
- SAR ADC Top level Design
Lecture 5: Mitigation of Time Skew in TI SAR ADC Generated by MUX for V2X
- Mitigation of Time skew in TI SAR ADC generated by MUX for V2X application
Lecture 6: Layout Challenges of a SAR ADC
- Layout challenges of a SAR ADC
Lecture 7: Mitigation of Time Skew in TI SAR ADC
- Mitigation of time skew in TI SAR ADC
- Layout challenges of TI SAR ADC
Lecture 8: Validating Design Robustness Across Corners and Monte Carlo Simulation
- Characterizing statistical variation in a comparator with Monte Carlo simulation
Lecture 9: Effect of Aging in GF 22nm FDSOI
- Aging simulation of comparator
- Electromigration simulation of SAR ADC